SSD's Next Home Could Be Enterprise Storage

Notebooks were a logical place for solid state drives, but desktops are not the next stop for the hard disk replacement technology.
Posted November 13, 2008

Andy Patrizio

The mobile market was an ideal launch point for the advent of solid state drive (SSD) technology because every one of SSD's strengths hit a point of need in mobility: they run cooler and faster than HDDs, they're smaller and draw far less power.

Now that prices are coming down – 64GB drives used to be $600, now they are between $160 and $200 – and capacities are rising, where will the SSD find its next use? If you guessed desktop PCs, guess again.

Samsung, one of the leaders in the memory market, believes the next big use will be as replacement drives for 15,000 RPM high-speed drives used in enterprise servers. It believes SSDs are faster, draw less power and run cooler than the 15,000 RPM drives, which are so hot you'll burn your hand if you touch one while it's running. Samsung also believes that 15k drives have a higher failure rate than slower running hard drives.

Just this week, startup Violin Memory announced enterprise storage products based on SSD technology.

"These datacenters are just carbon dioxide pumps," Stephen Weinger, marketing manager for NAND flash at Samsung, told "Their power emissions are huge. Not only power to run but power needed to cool the room because the drives run so hot. There's just racks of drives that could go down in size."

Drives have to be a certain square size because they have a rotating platter in them. An SSD is just a circuit board of chips, so it need not be the 3.5-inch or 2.5-inch form factor of a standard drive.

"This is where you can take advantage of the speed of SSDs," said Weinger. "A 15,000 RPM hard drive's IOPS is in that 300 range. An SSD is going to start at 2,000 and it's going to work its way up. So it's basically a replacement for 15k hard drives."

An IOPS is I/O per second, a measure of hard drive read performance. SSD drive makers routinely claim IOPS in the 10,000 range. On the very ambitious side of things is Texas Memory Systems, which makes a series of rack mounted SSD storage systems up to 4U in size that can scale into the terabytes of memory, with IOPS (I/O per second) of over 100,000.

SSDs pros and cons

But Krishna Chander, senior analyst with iSupply, begs to differ on some of these claims. For starters, he has never heard of high failure rates for 15,000 RPM drives; instead he says they have the same failure rates as other drives.

The real shortcoming for SSDs is their write performance. Major datacenter OEMs tell Chander SSD can't match the 15k drives. "It's not prime time yet for fast writes at this point," he told "The OEMs are saying they got a ways to go. But they are certainly considering them and certainly deploying them in high-read applications."

Next Page: Timetable for enterprise adoption

This article was first published on To read the full article, click here.

Tags: chips, datacenter, marketing, desktop, Storage

0 Comments (click to add your comment)
Comment and Contribute


(Maximum characters: 1200). You have characters left.